Electric Gate Installation Services

Automatic Driveway Gates

Driveway layout and slope determine whether a sliding or swing configuration will operate reliably through Denver’s temperature range. The install covers the gate panel material, the opener motor mount, the safety loop sensor and control box, and a full opening and closing cycle test before the job is signed off.

Bi-Folding Gates

The two-panel fold reduces the clearance arc by roughly 50 percent compared to a single-leaf swing gate, and the faster opening cycle suits high-use entries. The install covers post condition, the opener and control box, safety sensor alignment, and a full cycle check before the job is complete.

Custom Metal Fabrication

Off-the-shelf panels rarely fit non-standard driveway widths, and a mismatched frame weight overloads the opener within months. The opening is measured, the steel, wrought iron, or aluminum frame is fabricated to dimension, fitted to posts and hinges, and the latch aligned so the opener engages cleanly on every cycle.

Electric Gate Installation

Gate style, driveway slope, and power availability all determine which motor and configuration will perform reliably. The swing or slide operator is sized to your opening, the control box wired, photo eyes aligned, and a full open/close cycle test run before the visit ends.

Fleet & Logistics Gates

High-frequency truck traffic demands a gate motor sized for the cycle load and an opening wide enough for the largest vehicle on site. The entrance is measured, the gate type and operator selected, vehicle loop detectors and card reader or keypad access control installed, and a full load test run before the system goes live.

Industrial Gate Systems

Wide openings for truck traffic, high daily cycle counts, and integrated access control are the three variables that determine the right industrial gate configuration. The site assessment covers entrance width, the operator and steel gate construction, vehicle detection loops, and a full system test before handover.

LiftMaster Installation

Model selection starts with gate weight and expected daily cycles. An undersized control board shortens operator life fast. The install covers the arm mount, power supply wiring, travel limits, remote and keypad access programming, and a multi-cycle test to confirm the gate operator is calibrated correctly.

Smart Access Automation

A single gate can support multiple access methods simultaneously. Residents use a fob, contractors enter a time-limited keypad code, and delivery drivers are buzzed in via telephone entry. The install checks gate operator compatibility, configures multi-user management, and programs each access method before the system goes live.

Solar Estate Gates

Denver’s 300-plus sunny days per year support reliable solar charging, but panel wattage and battery voltage must be matched to gate motor draw and daily cycle count. The full system, panel, charge regulator, deep-cycle battery, and control board, is sized so the gate keeps running through overcast stretches.

Vertical Lift Gates

Vertical lift gates rise straight up on a support frame, so they work on hillside lots and tight urban entries where side clearance for a track is impossible. The install checks overhead clearance, sizes the counterbalance hardware to panel weight, and runs an opener cycle test before handover.